MOST EASY STEPS FOR WINDOW TINTING INSTALLATION PROCESS

 

First make sure you have following tools with you.

A spray bottle with soapy solution, Olfa knife and a squeegee.

Then start to install window tint as follows:

1. Prepare window glass: Wash the side of the window glass and spray it again with a soap solution. Remove any foraign matter with scraper or razor blade. Spray the entire surface with a soap solution.

2. Prepare the window film: Measure the surface of the glass and cut the film one inch wider and one inch longer than the required surface area. Stick the piece of tape on either side of the film. Pull each piech of tape outwards in apposite direction. By removing liner activate the adhesive by spraying soap solution. Apply the solution on the film including all the edges.

3. Apply film on glass: Pick up the film by corners and place the adhesive side against the glass, and get the proper position for it. For that, If you need to move film its ok, just go ahed. Check it by looking at all angles and make sure it's been placed properly.

4. Sueege out excess water and bubbles: Spray the side towards you with soap solution. Use your squeegee to remove the water from top to bottom.

5. Give finishing touch: Trim the excess film carefully using olfa blades or knifes. spray the film with soap solution and squeeze again to remove all excess water from under the window film. Place the paper towl on the squeegee and temp all the edges by stroking towards the glass frames. View the window from outside; if any bubbles are seen squeeze and remove bubbles.

Here you go! Your window is now looks far better than before. Tools play important role in every operation. Without tint tools you can not tint your window. So go ahed and buy tint tools now. We have all essential and quality tint tools. for more information contact today at buytinttools@gmail.com.